On Board Ultra SCSI Active Termination
Low Profile 1" high, Small Width Form Factor
The same attachment as a disk drive.

Click here
for info on 68 to 50-Pin adapters for LVD drives.
Click here for info on 68 to 50-Pin adapters for non LVD drives.
Click here for info on 68 to 68-Pin terminators.

click here for specifications
Integrate SCA - 80 Pin drives in existing systemsadapter illustrations

Trans Intl SCA-2 80 pin interface adapters provide easy integration of 80-pin SCSI drives to an 8 bit bus (narrow, 50-pin) or 16 bit bus (wide, 68-pin). These adapters are one inch high, with on board active SCSI termination. Since SCA-80 pin drives do not have SCSI termination these adapters eliminate the need for internal terminators.

Also available are several other drive parameters like SCSI ID selection, (7 SCSI IDs for 8-bit narrow drives, 15 SCSI IDs for 16-bit wide drives), LED jumper for drive activity status, drive delay start option, remote start option, sync spindle option and termination enable/disable option.

The 5 and 12 vdc voltages are delivered to the power plug that sources power from an 80-position power plane. These adapters are designed to meet Ultra SCSI specifications and can be used in RAID subsystems, disk arrays, external drive subsystems, and internal drive upgrades in computer subsystems.

Low Profile
One inch high Design
diagram showing dimensions Trans Intl low profile SCA SCSI adapters are only one inch high which allows them to easily integrate into systems that have a space limitation both in height and width.

The connector is only 3/8 of an inch wide.

Ultra SCSI

On Board Active Termination

SCA SCSI Adapters available in the market do not have active SCSI termination. Trans Intl SCA SCSI adapters use active terminators (exactly the same as used on disk drives). Drive termination can be enabled/disabled on the adapter board.

Ultra 2 SCSI CompatibilityNo Internal Terminator Required

Trans Intl SCA SCSI adapters are fully compatible with New Ultra 2 SCSI drives operating in single ended mode. Active termination on the adapter is fully compatible with Ultra 2 SCSI specifications.

Proper Shielding
Drive & Connector
Shielding Illustration Shielding is provided between the adapter and the drive. Without shielding the contacts at the back of the adapter may touch the metalic drive housing. This will either damage the drive or the computer.





Transintl LLC. 2120 East Howell Ave. Suite 412, Anaheim, CA 92806
Telephone: (714) 634-1583 • Fax: (714) 634-0409

sales@transintl.com

Copyright © 1998-2002. All rights reserved.
In business for 15 years.



Comments regarding the function of this site may be sent to the webmaster.